Stretch Ceiling Installation Prerequisites

Pre-Conditions for a Perfect Stretch Ceiling Installation

Ensure these pre-conditions are met before installing a stretch ceiling for a smooth, durable finish.

Room Completion: All major construction, painting, and plastering must be finished.

Dry & Dust-Free Environment: The space must be clean, dust-free, and moisture-controlled.

Existing Functional Space: Cover furniture and remove small items for a clean, damage-free process.

Electrical & Lighting Pre-Work

All wiring, fixtures, and mounting points must be in place before installation.

Place Outside the Stretch Ceiling

Avoid placing SMPS/drivers inside the stretch ceiling to prevent the need for fabric removal during servicing. Best Practice – Install drivers and power supplies outside the ceiling for easy access and future servicing.

In Case of Placement Inside the Ceiling

If it is absolutely necessary to place the drivers inside the stretch ceiling, ensure they are housed within a trap door or a removable access panel. This allows easy servicing without disturbing or removing the stretch fabric.

Distance from Drivers to Lighting Fixtures

The ideal distance between the driver and light fixture should be within 5 meters to avoid voltage drop and ensure consistent lighting performance. If the drivers need to be placed beyond 5 meters, ensure the proper wire thickness is used to compensate for the distance and avoid lighting loss. Please refer to the picture below where the illustration is based on 160W SMPS

Step 01

Install the profile and wood frame (fix them by nails at interval of 10 cm)

The aluminium harpoon profile is levelled and fastened to the wooden frame or wall perimeter. Nails are driven at 10 cm intervals so the profile stays perfectly straight and can hold the tension of the stretched film.

Nail interval – 10 cm
Laser levelled perimeter

Unfolding the stretch ceiling film and fixing its four corners

Step 02

Fix the four corners of film

The pre-welded film is unfolded and its four corners are anchored into the profile first. Setting the corners correctly squares the sheet and decides how evenly the tension will spread across the whole ceiling.

Corner-first anchoring
Even tension across the sheet

Softening the edges of the stretch ceiling film by heater

Step 03

Soften the edges of film by heater

A controlled heater warms the room and the edges of the PVC film, making it elastic enough to stretch without stress marks. Temperature is monitored throughout so the material expands uniformly.

Controlled heat application
No stress marks or creases

Step 04

Insert the harpoon with film into the profile

Working from the corners towards the middle of each side, the harpoon edge welded to the film is tucked into the profile track with a spatula. The lock is mechanical — no glue and no screws through the fabric.

Corners to centre sequence
Glue-free mechanical lock

Flattening the uneven parts of the stretch ceiling using a heater

Step 05

Flatten the uneven parts using heater

The heater is passed over the sheet once more so any remaining waves, dents or soft spots relax and pull out. As the film cools it tightens on its own into a drum-tight, mirror-flat plane with no ripples or sag.

Waves & dents removed
Drum-tight flat finish

Completed backlit stretch ceiling ready for handover

Step 06

Final check and handover — done

The ceiling is complete. Lighting is switched on for a final check, the area is cleaned and the space is handed back ready to use the same day — no debris, no repainting and no follow-up work.

Same-day handover
Factory warranty backed

Installation Pre Conditions